Structural weld inspection: what sampling ratio is right?
王工
Проверенный участник · Сервисный инженер
The client wants 100% ultrasonic testing on boom and swing platform welds.
Full inspection adds about six hours per machine and visible cost.
What ratio is usual, and how do you split critical from standard parts?
Discussion (3)
Г-н ЛюПроверенный участник · Сервисный инженер2026-10-22
Full inspection of load-bearing welds is reasonable; 20% sampling on standard parts is usually accepted.
Paulo M.Верифицированный участник · Главный инженер проекта2026-10-23
Supplying welding procedure qualification and welder certificates proves quality better than a higher ratio.
Ade O.Проверенный участник · Руководитель закупок2026-10-24
Cost can go into the quotation; what matters is that reports are truthful and sampling records kept.
Недавние ответы в этой теме, отсортированные по времени публикации
Присоединиться к обсуждению
Войдите, чтобы ответить; контент появится после проверки.
Войдите, чтобы ответить